Effect of Vanadium Addition at a Rate of 0.1% on the Mechanical Characteristics, Microstructure, and Microhardness of Al-Cu Casted Alloys

Abdallah Mahasneh, S. M. A. Al-Qawabah

Abstract


Due to essential need of Al-Cu alloys in different applications such as aerospace and automotive industries, and the mechanical characteristics of Al-Cu alloys being weak; the effect of vanadium addition at a rate of 0.1% on the mechanical behavior, microhardness, and microstructure have been investigated. The effect of upsetting process -cold work- on the microstructure, microhardness has been also investigated. Three set of alloys namely; Al, Al-9%Cu, and Al-9%Cu-0.1%V were prepared. The specimens for microstructure, microhardness and compression tests were machined. The mechanical tests were performed to investigate the effect of vanadium addition and the effect of upsetting process. It was found that the 0.1% vanadium addition resulted in grain refinement of Al-9% Cu alloys of about 32.3 %, furthermore, and extra refining resulted after upsetting process by 44.2 %. On the other hand, the microhardness of Al-9%Cu enhanced by 54.1 %, and the valuable result was a 422.8 % enhancement in the microhardness of Al-9%Cu-0.1%V alloy after upsetting process compared to pure Al.


Full Text: PDF DOI: 10.5539/mas.v5n2p92

Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.

Modern Applied Science   ISSN 1913-1844 (Print)   ISSN 1913-1852 (Online)

Copyright © Canadian Center of Science and Education

To make sure that you can receive messages from us, please add the 'ccsenet.org' domain to your e-mail 'safe list'. If you do not receive e-mail in your 'inbox', check your 'bulk mail' or 'junk mail' folders.