Microstructure and Creep Behaviour of as-cast Ti-48Al-4Cr

Esah Hamzah, Maiiyeaalagan Kanniah, Mohd Harun

Abstract


The microstructure and creep behaviour of as-cast beta phase contained gamma titanium aluminide with nominal composition of Ti-48Al-4Cr (at.%) was investigated. Constant load tensile creep test were performed at temperatures between 600-8000C and initial stresses from 150-180MPa. Data indicates that the alloy exhibit both steady state and minimum creep behaviour depending upon the temperature and stress. Microstructure before and after creep deformation were examined using scanning electron microscopy techniques. The possible reason for the transition from steady state to minimum creep behaviour was suggested.

Full Text: PDF DOI: 10.5539/mas.v3n1p164

Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.

Modern Applied Science   ISSN 1913-1844 (Print)   ISSN 1913-1852 (Online)

Copyright © Canadian Center of Science and Education

To make sure that you can receive messages from us, please add the 'ccsenet.org' domain to your e-mail 'safe list'. If you do not receive e-mail in your 'inbox', check your 'bulk mail' or 'junk mail' folders.