Effect of Blending Temperature on the Characteristics of Modified Polyacrylonitrie Homopolymer

Ahmad Fauzi Ismaila, Azeman Mustafa, Muhammad Syukri Abd. Rahaman


This paper examines the modification of polyacrylonitrile (PAN) homopolymer by a blending technique. The discussion on this modified PAN fiber involves the comparison a new concept of comonomer attachment compared to the conventional method. The PAN homopolymer and comonomers (i.e. itaconic acid (IA) and methylacrylate (MA)) were dissolved in dimethylformamide (DMF) at two different temperatures; 70°C (Type 1) and ambient temperature (Type 2). These fibers were fabricated using a simple the dry/wet spinning process before subjected to a stabilization process. FTIR result shows that the peaks (around 1600cm-1) indicated that the comonomers in Type 1 fiber were attached to the PAN homopolymer backbone during the dope preparation step. However for Type 2 fibers, the comonomers were only attached to the PAN homopolymer backbone during the stabilization process. Type 1 fibers also have higher weight loss and faster stabilization compared to Type 2 fibers. Therefore, the blending process at heat temperature of 70ºC is claimed as the technique that can modify the PAN homopolymer and make the stabilization process of PAN fibers faster.

Full Text:


DOI: https://doi.org/10.5539/mas.v2n2p131

Copyright (c)

Modern Applied Science   ISSN 1913-1844 (Print)   ISSN 1913-1852 (Online)  Email: mas@ccsenet.org

Copyright © Canadian Center of Science and Education

To make sure that you can receive messages from us, please add the 'ccsenet.org' domain to your e-mail 'safe list'. If you do not receive e-mail in your 'inbox', check your 'bulk mail' or 'junk mail' folders.