Vibration-Based Fault Diagnosis of Hydraulic Pump of Tractor Steering System by Using Energy Technique

Kaveh Mollazade, Hojat Ahmadi, Mahmoud Omid, Reza Alimardani

Abstract


This paper focuses on a problem of vibration-based condition monitoring and fault diagnosis of pumps used in the tractor steering system. The vibration-based machine condition monitoring and fault diagnosis incorporate a number of machinery fault detection and diagnostic techniques. The vibration signal from a piezoelectric transducer was captured for the following conditions: Normal pump (GOOD), Journal-bearing with inner face wear (BIFW), gear with tooth face wear (GTFW), and Journal-bearing with inner face wear plus gear with tooth face wear (G&BW) for three working levels of pump speed (1000, 1500, and 2000 rpm). Then Power Spectral Density (PSD) of vibration spectra was calculated. According to the results, fault diagnosis of hydraulic pump is a difficult task using spectrum of vibration signals alone. Results showed that different faults were showed different PSD versus frequency diagram. Comparison of numerical data produced by calculation the area under PSD v. Frequency diagram show that energy technique is an effective method for fault diagnosis of external gear hydraulic pumps.


Full Text: PDF DOI: 10.5539/mas.v3n6p59

Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.

Modern Applied Science   ISSN 1913-1844 (Print)   ISSN 1913-1852 (Online)

Copyright © Canadian Center of Science and Education

To make sure that you can receive messages from us, please add the 'ccsenet.org' domain to your e-mail 'safe list'. If you do not receive e-mail in your 'inbox', check your 'bulk mail' or 'junk mail' folders.