Creep Failures in Laser Welded 316L(N) Stainless Steel Joints


  •  D. Kumar    
  •  T. Shaktivelu    
  •  M. Nanda Gopal    
  •  K. Chandravathi    
  •  K. Laha    
  •  S. Albert    
  •  Hemanth Kumar    
  •  B. Shanmugarajan    
  •  A. SomiReddy    

Abstract

Low carbon, nitrogen alloyed 316L(N) SS is an high temperature structural material for Fast Breeder Test Reactor (FBTR) applications. Laser welding is a non contact, low heat input widely accepted welding process for welding a wide variety of materials due to its advantages like deep narrow welds, minimum distortion, narrow heat-affected zone, excellent metallurgical quality, ability to weld smaller size, thinner and thicker components and increased travel speeds compared to other welding processes. Creep rupture tests have been carried out on laser welded 316L(N) SS joints at 650ºC. The Rupture behavior of these joints has been investigated at stresses in the range 180–220MPa. In the present paper an attempt has been made to present the results on the creep failure mechanisms of creep–ruptured laser welded 316L(N)SS joints. It has been observed that creep fracture occurred in an inter granular fashion at all the stresses that have been tested and creep cavitation was the dominant mechanism in controlling the creep rupture behavior.



This work is licensed under a Creative Commons Attribution 4.0 License.
  • ISSN(Print): 1927-0585
  • ISSN(Online): 1927-0593
  • Started: 2012
  • Frequency: semiannual

Journal Metrics

Impact Factor 2022 (by WJCI):  0.583

Google-based Impact Factor (2021): 0.52
h-index (December 2021): 22
i10-index (December 2021): 74
h5-index (December 2021): N/A
h5-median (December 2021): N/A

Learn more

Contact