Compressive Sensing Based Robust Signal Sampling

Lianlin Li, Fang Li

Abstract


Signal processing methods have been changed substantially over the last several decades. Traditional sampling theorem of Shannon-Nyquist states that the sampling rate must be at least twice the maximum frequency presented in the signal; however, sampling at the Nyquist rate is inefficient because the signals of interest contain only a small number of significant frequencies relative to the band limit, although the locations of the frequencies may not be known a priori. Recently, compressive sensing (CS) has made a paradigmatic step in the way information is presented, stored, transmitted and recovered, by which we can acquire and reconstruct sparse signals from sub-Nyquist incoherent measurements. Three key ingredients of successfully implementing compressed sampling technique are sparsible/compressible probed signal, reliable hardware design, and low-cost computational algorithm. In this paper, we focused on two aspects about the robust sampling of sparsible/compressible signal, in particular, the design of compressed sampling hardware and the robust reconstruction via sparse Bayesian analysis. Primary results showed the high performance of proposed strategies.

Full Text: PDF DOI: 10.5539/apr.v4n1p30

Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.

Applied Physics Research   ISSN 1916-9639 (Print)   ISSN 1916-9647 (Online)

Copyright © Canadian Center of Science and Education

To make sure that you can receive messages from us, please add the 'ccsenet.org' domain to your e-mail 'safe list'. If you do not receive e-mail in your 'inbox', check your 'bulk mail' or 'junk mail' folders.

doaj_logo_new_120 images_120. proquest_logo_120 lockss_logo_2_120 udl_120.